LPL Louvered / Perforated Linear
Spec Sheet

This fixture is designed for suspension mounting for direct/indirect applications where aesthetics and performance are both needed. Virtually glare free and shadow free illumination.
Heavy gauge roll formed steel housing with optional perforated pattern and standard center louvers. Units are shipped with die cast aluminum joiners installed for suspension and structural continuity. Designed to mount on exact 4 foot, 8 foot, and 12 foot centers. Joiners will accept stems, single cable, and power cords as supplied by Horizon. Two die cast aluminum architectural ends available (Spade, Bull Nose). Optional lamp sleeves are available that allow for the adjustment of the up/down light produced by the fixture (order one per lamp).
All reflective surfaces are finished with a high reflectance, lighting fixture white polyester powder. Special finishes available upon request.
Optical System
The direct/indirect lighting configuration provides ample downlight for tasks or general illumination while providing an aesthetically pleasing uplight to brighten spaces and eliminate the “cave” effect.
Electrical System
ETL listed. Suitable for damp locations. Damp location emergency pack must be specified separately. Ballasts are solid-state electronic. Ballasts and lamp holders are replaceable without removing from ceiling. Discrete voltage must be specified for emergency pack options when wired with flex.